No modifications are needed for the following modules as they don’t use D0 and D1: Hardware settings for STM32 Nucleo F401REįor the STM32 Nucleo F401RE D0 and D1 is not connected by default, therefore we have to modify some Solder bridges. You can see SJ6 have to be soldered to the right to change D5 to P0_11: Have a look at the schematics at EmbeddedArtists website, page 3, SHT 4. The DM-TFT28-105 and DM-TFT35-107 does not need this setting (D5 is not used by these display modules). The hardware setting is needed for the following displays: Pin D5 and D13 is connected to the same pin on the MCU and a solder jumper need to be changed to use another pin. If your mbed device does not have an Arduino pin header you have to manually mix and match the signals, refer to our datasheets.īelow you find hardware settings for a couple of popular mbed hardware platforms.
Sometimes this require some hardware settings. When using mbed with DisplayModule's TFT screens, make sure you have full access to the Arduino pin header. Use DM-ADTAU-003 adapter for easy connection for the following displays: Use DM-ADTAU-001 adapter for easy connection for the following displays: 3.5" Touch TFT (Arduino pin header) DM-TFT35-107.2.8" Touch TFT (Arduino pin header) DM-TFT28-105.Here is the list with our mBed supported displays including links to the mBed component page, at the bottom of each component page you will find a link to a notebook page with more detailed information on how to set it up.
0 kommentar(er)
